APEX™ Slot Die - Auto Adhesive Applicator

ITW Dynatec’s APEX High Speed Slot Die Applicator is an air-operated hot melt adhesive applicator assembly with an optional filter manifold. The applicator is used with intermittent pressure and constant pressure hot melt adhesive supply units (ASUs). APEX models are offered in six different module configurations.

Each APEX High Speed Slot Die applicator features various combinations of adhesive valve slot die modules mounted to a single service block. Each module is opened and closed by air pressure. Springs are used to keep the stem seated when no air pressure is supplied to the head. The rate of adhesive flow from the applicator is determined by the adhesive pressure applied by the ASU’s pump, shim thickness and the amount of shim opening.

The applicator is heated by replaceable cartridge heating elements which are controlled by an integrated RTD sensor and electronic control. A single heat zone for the service block and die allows for only one temperature control point on models less than 390mm. Models longer than 390mm have two heat zones and control points. The APEX module(s) is mounted onto either a steel or aluminium service block. A piston inside the module is pneumatically triggered by a solenoid, which allows adhesive to flow through a valve within the module.

The APEX offers a variety of heated adhesive supply hose connections into the service or filter manifolds. Adhesive flows from the hose into and through the channels within the manifold to the module. Air pressure opens the adhesive valve, allowing adhesive to flow through the module’s die assembly when the valve is open.

In order to minimize response time, operating air and electrical connects from the solenoid valves are made to each individual module

These slot die applicators can be configured for either ITW Dynatec’s DynaControl controller, Microprocessor Temperature Control/ Compu- Vision (MCV), DynaPlus/ Pro or it can be configured for a competitive upgrade.

Precise high speed intermittent adhesive patterns
Self-cleaning die lips permit the use of a variety of adhesive viscosities
Exceptional value for a high speed slot die applicator
Slot die design does not require micro adjustments to achieve the required adhesive lay down weights
APEX™ SD module provides a clean adhesive cutoff regardless of the adhesive pattern

Technical Spec:
Maximum on/off cycle speed 10,000 cycles per minute
Application width up to 500 mm / 19.6 in.
Adhesive viscosity 100 cps min / 20,000 cps max
Maximum operating temperature 200°C / 390°F
Pneumatic pressure 74 psi (5 bar) min / 125 psi (9 bar) max
Adhesive pressure 100 psi (7 bar) min / 1,000 psi (68 bar) max
230 VAC, 50/60 Hz, 1 phase with 24 VDC control voltage (custom configurations available)

Email: sales@universal-adhesives.co.uk